Today, a new jailbreak tool was released. Before you get your hopes up note that it only works for the iPhone 4. The new jailbreak, Ragebreak, uses the limerain exploit that was used on the iPhone way back on iOS 4. This is possible due to the nature of the exploit and only works with devices running an A4 processing chip. When iOS 7 was released Apple did not make any device other than the iPhone 4 compatible with the upgrade. While this jailbreak only works on one device we figured the tutorial would be useful for anyone in this particular situation. If you have an other device running 7.0.4 you will have to wait until the next jailbreak release.
![]()
*This jailbreak ports Cydia to iOS 7 which causes many glitches and many packages will not support the upgrade.
1. Download Ragebreak, Java dev kit (and install it), and iOS 7.0.4 firmware
2. Open the Ragebreak application (If it does not open go to system prefs, security and privacy, and under the
general tab allow apps downloaded from anywhere)
3. Once the terminal opens type “1″ and hit enter, if it prompts you to download Xcode do so.
4. Plug in your iPhone and enter DFU mode.
5. Continue the Ragebreak shell using the password “alpine”.
6. After it is finished continue to the app and re enter DFU mode
7. Type the corresponding number into Ragebreak and wait for reboot.
8. In the main ragebreak screen type 5 and enter your phones ip address
9. Type yes and “alpine” for your password
10. Boot tethered again by entering DFU and following step 6.
This is a tethered jailbreak you will have to boot tethered every time your device powers off
If you get confused use Tanner’s video to help along the way
*This jailbreak ports Cydia to iOS 7 which causes many glitches and many packages will not support the upgrade.
1. Download Ragebreak, Java dev kit (and install it), and iOS 7.0.4 firmware
2. Open the Ragebreak application (If it does not open go to system prefs, security and privacy, and under the
general tab allow apps downloaded from anywhere)
3. Once the terminal opens type “1″ and hit enter, if it prompts you to download Xcode do so.
4. Plug in your iPhone and enter DFU mode.
5. Continue the Ragebreak shell using the password “alpine”.
6. After it is finished continue to the app and re enter DFU mode
7. Type the corresponding number into Ragebreak and wait for reboot.
8. In the main ragebreak screen type 5 and enter your phones ip address
9. Type yes and “alpine” for your password
10. Boot tethered again by entering DFU and following step 6.
This is a tethered jailbreak you will have to boot tethered every time your device powers off
If you get confused use Tanner’s video to help along the way